ShineMate 5" Multi-hole DA backing Plate (5/16” x 24) p.p.6inch Load the Foam Cannon with

Load the Foam Cannon with a soap/water mix and attach it to your pressure washer (follow the wash or snow foam dilution ratio instructions)

the addition of specialized Ceramic (SiO2) polymers forms a reagent in solution

Exterior marine

Use a new side of the towel for each panel

Compact and lightweight

ShineMate 5" Multi-hole DA backing Plate (5/16” x 24) p.p.6inch Load the Foam Cannon withShineMate 5 inch Vented DA backing Plate, 5 16 x 24 thread, common for most short throw polishers. Multi hole backing plate to keep the temperature down when polishing, a must for hot dry summer days. If and when the heat builds up too much while polishing, it can soften the glue and the hook and loop surface and delamination may occur. Excess heat can also cause the foam structure to collapse and disintegrate over time. Will fit Porter Cable 7424XP,