Europa Tools Carbide End Mill 4 Flute Square Edge - Long Length - Pulsar DMX - 4mm x 20mm Morse Taper Adaptor ABSOLUTE sensor—no origin setting on

ABSOLUTE sensor—no origin setting on power-up: Start measurements immediately after switching on

The tapered ball nose geometry enhances surface finish and improves chip evacuation

Hardened steel construction: Resists wear and deformation under repeated use

supporting efficient workflow and reduced setup time

so you can rely on clean cuts and repeatable results

Europa Tools Carbide End Mill 4 Flute Square Edge - Long Length - Pulsar DMX - 4mm x 20mm Morse Taper Adaptor ABSOLUTE sensor—no origin setting onEngineered for deep pocket machining, the Europa Tools Carbide End Mill features a 4 mm diameter and a 20 mm flute length, designed to deliver precise, durable cuts in hard steels. Its long length design and Pulsar DMX coating make it ideal for engineers and shops tackling deep cavities and hard to reach areas at high speeds. Diameter x flute length: 4 mm diameter with 20 mm flute length for extended reach in deep pockets Flute configuration: 4 flute